551.PNG (Copy) (Copy)
large panic.PNG (Copy) (Copy)
small panic.PNG (Copy) (Copy)
551.PNG (Copy) (Copy)
large panic.PNG (Copy) (Copy)
small panic.PNG (Copy) (Copy)

2005 - 2008 Chrysler 300C 4 Button Remote Head Key with Transponder - KOBDT04A

from $45.00

SKU: 551

Condition:  Multiple Options

IMPORTANT: To ensure you're purchasing the correct key, please verify with an existing remote key that there is a screw holding the back piece on (if you are still using the OEM remote). Alternatively you can check the front panic button. The KOBDT04A has a wide panic button, whereas the other FCC ID remote head keys have a smaller panic button (as shown in picture).

Fits:

2005 - 2008 Chrysler 300C

OEM Part Number:  05179512AA, 05179512AB, 05179514AA, 05183349AA, 56038749AG, 68004413AA

FCC ID:  XKOBDT04A

Battery size: CR2032

Condition:

SKU: 551

Condition:  Multiple Options

IMPORTANT: To ensure you're purchasing the correct key, please verify with an existing remote key that there is a screw holding the back piece on (if you are still using the OEM remote). Alternatively you can check the front panic button. The KOBDT04A has a wide panic button, whereas the other FCC ID remote head keys have a smaller panic button (as shown in picture).

Fits:

2005 - 2008 Chrysler 300C

OEM Part Number:  05179512AA, 05179512AB, 05179514AA, 05183349AA, 56038749AG, 68004413AA

FCC ID:  XKOBDT04A

Battery size: CR2032

Extended 2 Year Warranty
Extended 2 Year Warranty
$7.99
Button Cell Battery (Choose Your Size) Button Cell Battery (Choose Your Size) Button Cell Battery (Choose Your Size) Button Cell Battery (Choose Your Size) Button Cell Battery (Choose Your Size) Button Cell Battery (Choose Your Size) Button Cell Battery (Choose Your Size) Button Cell Battery (Choose Your Size)
Button Cell Battery (Choose Your Size)
from $5.00
Size:
Pre-Cut Key Service Pre-Cut Key Service Pre-Cut Key Service
Pre-Cut Key Service
from $5.00
Type:

Step by Step How to Programming Instructions:

If you have two programmed working keys use the following instructions to program an additional key.


Sentry Key Programming

You can program new keys to the system if you have two valid sentry keys by performing the following procedure:

 

1. Cut the additional Sentry Key Transponder blank(s) to match the ignition switch lock cylinder key code.

 

2. Insert the first valid key into the ignition switch and turn the ignition switch ON for at least 3 seconds but no longer than 15 seconds. Turn the ignition switch OFF and remove the first key.

 

3. Insert the second valid key and turn the ignition switch ON within 15 seconds. After ten seconds, a chime will sound and the Theft Alarm Light will begin to flash. Turn the ignition switch OFF and remove the second key.

 

4. Insert a blank Sentry Key into the ignition switch and turn the ignition switch ON within 60 seconds. After 10 seconds a single chime will sound. The Theft Alarm Light will stop flashing, turn on for 3 seconds; then turn off. The new Sentry Key has been programmed.


Repeat this procedure to program up to 8 keys.